Repair Stories

Maytag Dryer Not Heating in East Lake Woodlands, Oldsmar: Heating Element Replaced

Old heating element next to a new one on the floor beside a Maytag dryer in an East Lake Woodlands, Oldsmar home
Symptom
Electric dryer ran but didn't heat.
Cause
Failed heating element with burnt terminals.
Fix
Replaced the heating element on site.

This Maytag electric dryer in the East Lake Woodlands neighborhood of Oldsmar was running, but it wasn’t heating. It’s a model MEDC465HW0, sitting next to a top-load washer in the laundry room.

Maytag dryer in a laundry room next to a washer, with our tool bag on top Maytag dryer data plate, model MEDC465HW0, with the serial number and barcodes blurred

What we found

The heating element is a coil of wire that gets hot when power goes through it, and the dryer blows air across it. We took the dryer apart and pulled the element out. The terminals on the end of it were burnt black, and the element had failed.

Close-up of the old dryer heating element with burnt, blackened terminals

The fix

We replaced the whole heating element with a new one, put the dryer back together, and it was fixed the same visit. The old element is on the left in the photo, the new one on the right. If your dryer spins but the clothes come out damp, our dryer repair service can sort it out.

FAQ

Why does an electric dryer run but not heat?

A failed heating element is a common cause. The drum still turns because the motor is fine, but the element is what makes the heat. On this Maytag in Oldsmar the element's terminals were burnt.

Can a dryer heating element be replaced at the home?

Yes. We replaced the element in this Maytag during the same visit, since we had the part with us.

See more appliance repairs in Oldsmar →

More dryer repairs

Dryer repair service →