Whirlpool Dryer Not Heating in Safety Harbor: New Heating Element, Fixed on the Spot
- Symptom
- Dryer ran but didn't heat.
- Cause
- Burned heating element.
- Fix
- Replaced the heating element with a Whirlpool factory part, on site in one visit.
This Whirlpool front-load dryer in Safety Harbor, model WED9050XW0, wasn’t heating. We came out, opened it up, and fixed it on the spot.
What we found
On an electric dryer like this one, the heating element is a long coil of wire that glows hot and warms the air blowing through the drum. When it burns out, the drum still spins and the dryer runs, but the clothes come out damp.
Here the old element was dark and scorched. That’s it on the bottom in the photo, next to the new Whirlpool factory part we brought.
The fix
We swapped in the new element and put the dryer back together.
The dryer was back in service the same visit, with no waiting on parts. If your electric dryer runs but doesn’t get hot, our dryer repair service covers this kind of job in Safety Harbor and the surrounding area.
FAQ
Why does my Whirlpool dryer run but not heat?
On an electric dryer, a burned heating element is a common reason. In this Safety Harbor job the old element looked scorched, and a new one got the dryer heating again.
Can a dryer heating element be replaced during the same visit?
Yes. We had the part with us for this Whirlpool dryer and finished the repair on site.