Repair Stories

Amana Dryer Not Heating in Dunedin: Burned Thermal Cutoff Replaced, With a New Cycling Thermostat

Back of an Amana electric dryer with the rear panel off, showing the heater housing, the blower and a multimeter hanging on the cabinet in a Dunedin laundry room
Symptom
The dryer turned but didn't heat.
Cause
A burned thermal cutoff. The vent looked clean, so the cycling thermostat may have let it overheat, or the fuse may have just worn out.
Fix
Replaced the thermal cutoff and the cycling thermostat on site.

A client in the Waterford Crossing neighborhood of Dunedin called because their Amana electric dryer, model NED4655EW1, turned but didn’t heat.

Amana dryer data label with model NED4655EW1 readable; serial number and barcodes blurred

What we found

The thermal cutoff, a safety fuse on the heater, had burned out. With it blown, the drum still turns but the dryer doesn’t heat.

Amana dryer with the back panel off and the exhaust duct pulled away, showing the blower, heater housing and a multimeter

The vent looked clean, so a blocked vent wasn’t the obvious cause.

The repair

We installed a new thermal cutoff and a new cycling thermostat. The cycling thermostat is the regular one that turns the heat on and off. It may have been working wrong and letting the dryer overheat. The fuse may also have simply worn out, or there could still be a venting problem.

Genuine Whirlpool thermal cutoff part, W10900067, in its bag Two dryer thermostats lying on the tile floor, one black and one silver

We repaired it on site. If the problem comes back, the next step is to have someone go up on the roof, since it’s high, and check the vent termination on the end of the duct.

If your dryer runs but doesn’t heat, call us. Our dryer repair service covers Dunedin, Palm Harbor, Clearwater and nearby.

FAQ

Why does my dryer spin but not heat?

A burned thermal cutoff is a common cause. It's a safety fuse that cuts power to the heater if the dryer gets too hot, and once it blows, the drum still turns but there's no heat.

Does a blown thermal cutoff always mean a blocked vent?

Often, but not always. Here the vent looked clean. The cycling thermostat could have been working wrong and overheating the dryer, or the fuse could have simply worn out. If it blows again, we'll check the vent termination on the roof.

See more appliance repairs in Dunedin →

More dryer repairs

Dryer repair service →