Repair Stories

GE Wall Oven Showing F3 in Dunedin: Loose Temperature Sensor Replaced, but the 30-Year-Old Control Is Discontinued

White GE 27-inch electric wall oven with an electronic control panel built into wood cabinets in a Dunedin kitchen
Symptom
The oven showed error F3.
Cause
The oven temperature sensor was loose and hanging on its wire. After we replaced it the error stayed, which points to the control board.
Fix
Replaced the sensor. The control board is discontinued and there's no alternative, so we recommended replacing the whole oven.

A homeowner in Dunedin asked us to check their GE wall oven. The oven is from 1997, and it was showing error F3.

GE wall oven data label with the model number readable and the serial number blurred

What F3 means

The oven came with its tech data sheet. According to its diagram, F3 is an error for the oven temperature sensor circuit: it’s open or shorted. The sheet tells you to measure the sensor’s resistance, which should be about 1100 ohms at room temperature, and to check the sensor wires and connectors.

The loose sensor

We pulled the oven out and found the temperature sensor wasn’t secured. It was just hanging on its wire.

Inside the oven cavity, the temperature sensor hanging loose on its wire against the back wall above the rack The GE wall oven pulled out of its cabinet opening with its top cover open, with a flashlight and tools beside it

We had that sensor in stock and replaced it, since the old one was damaged.

The control board

The oven still showed the same error after the new sensor went in. That points to the control board.

The oven's electronic control board with its relays and wiring connectors, seen from behind the control panel

The unit is almost 30 years old, and the control board has been discontinued. We couldn’t find an alternative.

With no board available, we recommended replacing the whole oven.

The oven came with its tech data sheet, so we typed up the error codes, sensor test and special functions on our site.

If your oven shows an error code, call us. Our oven repair service will tell you honestly whether it’s worth repairing, in Dunedin, Palm Harbor, Clearwater and nearby.

FAQ

What does error F3 mean on an older GE wall oven?

On this GE, the tech sheet lists F3 and F4 as an open or shorted oven temperature sensor circuit. It says to check the sensor's resistance, which should read about 1100 ohms at room temperature, and to replace the control if everything else is fine.

What if a 30-year-old oven's control board is discontinued?

Then it can't be repaired by swapping the board. We couldn't find an alternative for this one, so replacing the oven was the practical option.

See more appliance repairs in Dunedin →

More oven repairs

Oven repair service →